Request UE32J5500 BN41-02353b Emmc Dump

[lolville]

Hello!
Im looking for an emmc dump for UE32J5500 BN41-02353b.

Already programmed from this thread the dump from Mr. Abu Mahdi [External Link Removed for Guests] but now red led blinks 6 times.


Can anyone help me please?

Thanks!

[ابو عبد الله]

Turn off your Samsung TV using the remote control or the on/off button on the TV.
Unplug your Samsung TV from the outlet on the wall. If you have not done so, check the plug and the outlet for signs of damage or overheating.
If your Samsung TV is plugged into a surge protector, unplug the TV power cord from the surge protector as well.
Let the TV sit for at least 15 minutes with no power connected.
After 15 minutes, press the power button on the TV for about 60 seconds
After one minute and while still holding the power button, plug the Samsung TV power cord back into the outlet. Bypass your surge protector, if you use one, for the time being.
Release the power button and then press the button again. If the reset successfully fixed the problem, your Samsung TV should come on and operate normally.

[ابو عبد الله]

If your Samsung TV persists in blinking the red LED light 6 times, one more reset is available. This is a soft reset and is performed using the buttons on the TV and not the remote control.

[lolville]

Hello. Thanks for the help. Original fault was having random glitches on the screen, menus were scrambled. I already replaced tcon and screen and did a factory reset. Pretty sure the emmc was faulty. Now after flashing the emmc that I mentioned above the led flashes 6 times. So flashing 6 times is not the original fault, but is a result of flashing another emmc from [External Link Removed for Guests]

[lolville]

Already used another dump, which I will post later in the forum. Tv stuck on logo now. I think the only solution would be emmc replacement.